skip to Main Content

انرژی خورشیدی تحلیل جریان کمینه برای سیستم حرارتی خورشیدی برای گرمایش آب

عنوان انگلیسی: An analysis of low flow for solar thermal system for water heating
سال نشر: ۲۰۱۹
نویسنده: Francisco Plaza Gomariz,José Manuel Cejudo López,Fernando Domínguez Muñoz
تعداد صفحه فارسی: ۸ – تعداد صفحه انگلیسی: ۷
دانشگاه: Grupo de Energética, Escuela de Ingenierías, UMA, C/Doctor Ortiz Ramos s/n, E29071 Málaga, Spain
نشریه: Process Safety and Environmental Protection
کیفیت ترجمه: اقتصادی

چکیده

نرخ جریان جرمی در حلقه جمع‌کننده سیستم آب داغ داخلی خورشیدی (SDHW)بر عملکرد حرارتی آن تاثیر می‌گذارد. سرمایه‌گذاری اولیه و هزینه عملیاتی نیز تحت‌تاثیر انتخاب جریان اولیه هستند. قوانین طراحی متداول یک نرخ جریان خاص استاندارد ۵۰ L / hm۲ را برای بیشتر مدل‌های کلکتور در نظر می‌گیرند. با این حال، ظهور موتورهای احتراق به صورت الکترونیکی توجه به مزایای جایگزین های جریان کم (۷ الی ۱۴ لیتر در hm۲) را برای سیستم‌های حرارتی خورشیدی توصیه میکند.
در این مقاله، عملکرد حرارتی یک کلکتور مارپیچی معمولی برای نرخ‌های مختلف جریان جرمی اندازه‌گیری شده‌است. منحنی‌های عملکردی حاصل و بندهای عدم قطعیت مربوط به اندازه‌گیری، تنها یک بهبود متوسط در عملکرد نشان می‌دهند زیرا نرخ جریان افزایش می‌یابد. هنگامی که رفتار حرارتی کلکتور مشخص شد، کل سیستم مدل‌سازی شده، و هزینه سرمایه‌گذاری اولیه و عملیاتی برای دو گزینه طراحی محاسبه می‌شوند: جریان بالا (۸۰ l / hm۲)و جریان پایین (۲۰ لیتر در hm۲). همانطور که انتظار می‌رفت، کسر خورشیدی برای سیستم جریان بالا کمی بالاتر است (۴.۶ % بیشتر)و تعداد ساعات عملیات برای این سیستم (۴.۴

Abstract

Highlights•Two SDHW working strategies are simulated and compared, for low and high flow.•The test curves used for simulations are obtained according to the SST from EN12975.•There are no differences in the test curves obtained for quite different flows.•Economic-energetic comparison for low and high flow SDHW recommends low flow.•EC pumps are not justified when installed in moderates climates like Mediterranean.AbstractThe mass flow rate in the collector loop of a solar domestic hot water system (SDHW) affects its thermal performance. The initial investment and the operation cost are also affected by the selection of the primary flow. Common design rules state a standard specific flow rate of 50 l/hm2 for most collector models. However, the emergence of electronically commuted motors recommends reviewing the interest of the low flow alternative (7–۱۴ l/hm2) for solar thermal systems.In this paper, the thermal performance of a typical serpentine collector has been measured for differen
امتیاز شما:
(No Ratings Yet)
Back To Top